Hey guys recently did new front floor pans.
![401225]( "401225")
Looking to put bucket seats in my 62 coupe. It came with bench. What do I need other then the seats themselves? Also are the buckets for 62 same as the rest? As far as bolt spacing goes?
Kdizzle
Joined
·
17,783 Posts
Yes 62-64 are the same. 1965 folds straight forward instead of at an angle. They are also very slightly narrower than 62-64. '67 is different than '66 in that it has a seatback lock distinguishable by a button on the door side edge of the seatback.
Joined
·
17,783 Posts
It's hard to tell if they are '67 Nova or not. The covers are not '67 Nova, but could be after market applied. These could also be after market recovered Chevelle buckets. The picture of the buckets you've posted show them in a 1st generation Chevy II (62-65) 2 door sedan. No matter what year it is, this car would have had a bench seat. The way these seats are mounted in the 2 door sedan should be able to be replicated in your '62 that had a bench seat.
Bob
Bob
Joined
·
17,783 Posts
Sorry, I missed the part where you stated they were bolted directly to the floor. No, you don't want to do that again. I know there are members here who have done this swap, Hopefully, they'll post.
B.
B.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
