Need to pull the engine from my 62 to do floor pan replacement.
Wondering if I can attach my engine hoist to the ends of the cylinder heads using the tapped holes? Will be attaching at each end of both heads. I know they have a plate that attaches where the manifold is, but I don't want to pull that off.
Engine is an aluminum LS1 from a 2000 TransAm. Will be lifting the engine with the trans (4L60E) attached. I can remove the trans if that makes a difference.
Thanks for the help.
Wondering if I can attach my engine hoist to the ends of the cylinder heads using the tapped holes? Will be attaching at each end of both heads. I know they have a plate that attaches where the manifold is, but I don't want to pull that off.
Engine is an aluminum LS1 from a 2000 TransAm. Will be lifting the engine with the trans (4L60E) attached. I can remove the trans if that makes a difference.
Thanks for the help.
