Chevy Nova Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
921 Posts
Discussion Starter #1
i have a bunch of parts sittin around and i was wondering if there is a junkyard shortblock i could use them on. i have a set of dart pro 1 215 heads with 64cc chambers, a strip dominator intake with a 75o dble pumper, an rpm air gap(made by dart), a hyrdaulic roller cam setup(242 [email protected] .50 .540 .560 lift on a 110), i also have a th350 and a 3000-3500 converter to go with it. i know all these parts will bolt up to any small block but im looking for something that is compatable compression wise.i had this all on a 11 to 1 400 sbc before. any info on what engine i could use and what it comes in would be greatly appreciated. thanx in advance
 

·
Premium Member
Joined
·
10,210 Posts
hmmm....a junkyard short block that will need no work and that can support those parts(preferable at least 10:1cr and even that is a little low for that cam)...ummm...what year is this????...cause if its not 1970 I think your outta luck...those motors, found in that condition, in a junkyard are looooooong gone IMO...sorry :eek:
 
1 - 2 of 2 Posts
Top