What holds in the radio delete plate 69

885 Views 3 Replies 3 Participants Last post by nodice333, Jul 23, 2012

nodice333

Discussion Starter · Jul 23, 2012

Im doing the whole less is more for my 69, i am doing a heater and radio delete. I have already installed a factory heater delete plate on the dash and removed the heater switches, i also have a really nice radio delete plate. Ive seen 2 kinds, one where no hole was cut for the radio and another were a matching plate covers the hole, i have the plate type, it fits nicely and looks cool but what is used or could be used on the backside to keep it firmly in place?

Save

1 - 4 of 4 Posts

Roger Connolly

· #2 · Jul 23, 2012

plates

I used a couple dabs of silicone, not too much so you can get it off if you have too. Been on there for a couple of years now and no problems. Good Luck

Save

TechNova

· #3 · Jul 23, 2012

I had one many years ago, I remember it having two "posts" molded into the back. Two 1/4" headed screws with large washers threaded into these posts.

Save

nodice333

Discussion Starter · #4 · Jul 23, 2012

TechNova said:
I had one many years ago, I remember it having two "posts" molded into the back. Two 1/4" headed screws with large washers threaded into these posts.

yea it still has 2 post on the back but they have not been threaded yet but i can change that

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month