Chevy Nova Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2,277 Posts
Discussion Starter #1 (Edited)
My old M/T valve covers do not align properly with my World heads. I am figuring thats because the World's have thicker walls (or rails).

I am looking at this set (link below) because they will work with my heads but also because I am a big Motown music fan. :D My old setup had a breather on the passenger side and a oil fill cap in the front and a rubber grommet in the rear for vacuum to my brake booster on the drivers side. These Motown covers will have one breather provision at each cover. Nothing in the back on the drivers side (with Motown logo oriented properly) Therefore I wll not be able to hook up my pvc / brake booster line at the drivers side rear. So the question is, where can I locate my pvc and can I just run the brake booster to a port on the manifold or directly to the carb? Also, ok to run a breather on the back of the cover on the passenger side? i ask because I see a lot of breather setups towards the front on each side. thanks a lot!

http://www.yearone.com/serverfiles/fbshopmain2.asp?input=chevy+motown+valve+covers&SM=1&SC=6

and regarding Motown music.....
http://www.youtube.com/watch?v=GVgu_se6HgA&feature=channel_page
 

·
Registered
Joined
·
2,146 Posts
you can run the hose for your booster either to the manifold or the back of the carb. If you valve covers don't have any holes in them my suggestion would be to get a hole drilled somewhere to either run breathers or one breather and pcv valve.
 
1 - 2 of 2 Posts
Top