[NickyRudolph]

Anyone have any knowledge on the pivotball height? I measured mine to be 1/16th taller than the recommenced 4.75” yet I still don’t have the 5-7° forward angle on the fork. I have the adjustable pivot ball but I’m wondering if I should use a longer t/o bearing to get to the 5-7° or just adjust the pivot ball

 

[Alf]

Essentially, there are two size TO brgs. The tall is for diaphragm clutches and the short is for three finger and bent finger diaphragm clutches. They don't interchange.
Assuming you have the correct fork, Z bar and linkage adjustment you have to adjust the ball.