Chevy Nova Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
Mocking up the 64 with the CPP full front end kit.

Have question on the steering column down to the new power rack

Using the original steering column and shaft. Took the gear apart and cutoff at the worm gear.

So have the shaft but what are you guys using to support the original shaft at the bottom of the steering column?

We have the 23 spline and 3/4 DD ujoint, and 3/4 DD intermediate shaft and a 3/4 DD to 3/4 DD ujoint to the original steering shaft.

I am planning on cutting and grinding original steering shaft to fit the 3/4 DD ujoint.

But how am I going to support the original shaft at the bottom of the column????

I'm kind stuck on this who can help?

I know some was doing this awhile back but cant find the post.
 

Attachments

1 - 4 of 4 Posts
Top