Chevy Nova Forum banner
1 - 5 of 5 Posts

·
Premium Member
1965 2door HT Helena, GA 31037
Joined
·
1,889 Posts
Discussion Starter · #1 ·
Another dumb question. I cleaned my original spindles and steering arms and got them ready to go on the CBR control arms. Since they were rusty it appears they were not painted originally. I would really like to powder coat but that is two 170 mile round trips to get that done. Should I prime and paint them before installation or just leave them bare?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top