Chevy Nova Forum banner
1 - 18 of 18 Posts

·
Premium Member
Joined
·
2,948 Posts
Discussion Starter · #1 · (Edited)
Dial-up beware! Took some poster pics!!!

I snapped off some new pics and two videos. This is after a upgrade to the ZZ4 of an LT4 hotcam, roller rockers, Edelbrock air gap, Holley 750, new 3 inch stainless steel exhaust with Dynomax UltraFlows and an MSD ignition system (with a new MSD dizzy).. I'm no camera man so, don't rag on me.











Here are two videos (give them time to download)

Drive down the road
 

·
Premium Member
Joined
·
31,194 Posts
This is some serious 3rd gen eye candy, you've done a great job making a good car, great!
 

·
Registered
Joined
·
1,050 Posts
Not a camera man? Kind of hard to take a bad picture of that car! :)

Scott
 

·
Registered
Joined
·
372 Posts
Real nice looking car you have there! I dig the lower body mouldings. I'm having a hard time finding the fasteners for the quarter panel portion. Were those on the car or did you find the fasteners some place and if so where? I found the moulding but the smaller sections that are on the quarter did not come with mounting hardware. Let me know if you get a chance but anyway great car.:yes:
 

·
Premium Member
Joined
·
2,948 Posts
Discussion Starter · #13 ·
Real nice looking car you have there! I dig the lower body mouldings. I'm having a hard time finding the fasteners for the quarter panel portion. Were those on the car or did you find the fasteners some place and if so where? I found the moulding but the smaller sections that are on the quarter did not come with mounting hardware. Let me know if you get a chance but anyway great car.:yes:
Luckily for me they were on the car when I got it. As you are finding out in a small way, I heard these moldings were hard to find. Not sure were you would get the hardware, try Classic Chevy and ss396.com
 
1 - 18 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top