[QIKENUF]

I suppose I will keep the words to a minimum and will just answer questions about the pics as they come. To start off....

The car as it started.

Before sandblasting after tear down. You can see the car is pretty messed up. It is in need of quite a bit of attention.

After sand blasting.

First, I replaced the floor pans. They were pretty bad in several spots.

 

[QIKENUF]

Next, I moved on to the wheel tubs and quarters. Widened the tubs 1.5 inches.

Here I put up the bumper just for some looks. I am getting rid of those 5 mph crash shocks and sucking the bumpers up to the body like this.

I also took out the leaf springs and shocks and put in a custom triangulated four link and coil overs. It has a pretty wicked stance I think in the rear now. I will need to lower the front as well though.

 

[QIKENUF]

Next I moved on to the sub frame connectors. I did not see any point in spending lots of money on something so simple, so I made my own for less than $20.

This one is of the hole I had cutout to put in the cross member and drive shaft loop, with the patch put back in.

 

[QIKENUF]