Chevy Nova Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I'm trying to add the power steering pump to my 250 inline 6. The engine is a 74, I picked up a pump and brackets but the pulley on the pump is too far forward for my pulleys..

Is there a way of changing to a different pump pulley, or so I need something different?
 

Attachments

·
Registered
Joined
·
6 Posts
Discussion Starter · #5 ·
Pulley selection and alignment can be confusing since they vary. It looks like you have a PS Pulley with minimal offset distance (0.92") from the front of the pulley to the center of the pulley groove. A pulley with a deeper offset distance (1.5") should give the proper alignment. Summit has several pulleys reasonably priced but they don't all give the offset distance, so you might have to ask for that measurement.
So I think the double pulley will work, but I think I have the wrong from pump bracket I think I need a 343301 bracket.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #7 ·
I bought the parts of ebay and the guy said they were all there. But the front bracket was not . So I bought what I thought was the correct front bracket for my rear bracket ,but the bend in the front bracket was too wide. I need bracket number 355789, I may have to cut and weld the front bracket to make it work...
 
1 - 4 of 4 Posts
Top