Chevy Nova Forum banner

1 - 12 of 12 Posts

·
Premium Member
Joined
·
481 Posts
Discussion Starter #1
Does anyone in SoCal have one of these that I can borrow or buy second hand? I've seen too many people get stuck on the wrong back space rims etc. Thanks
 

·
Vendor
Joined
·
7,085 Posts
Flyer has one but I think its in Arizona, I will be looking to borrow/rent .... one as well:D
 

·
Registered
Joined
·
809 Posts
The Percy tool is a POS,I made my own and it did exactly what it was made to do.Brian,you can borrow this if you want to.I got offset dead on to put the 17-7,17-8s on my 63.The bare wheel on the car is an 18 inch wheel,too big so I didnt use the set for the rear.
[/IMG]
[/IMG]
[/IMG]
[/IMG]
 

·
Premium Member
Joined
·
4,597 Posts
The Percy tool is a POS,I made my own and it did exactly what it was made to do.Brian,you can borrow this if you want to.I got offset dead on to put the 17-7,17-8s on my 63.The bare wheel on the car is an 18 inch wheel,too big so I didnt use the set for the rear.
[/IMG]
[/IMG]
[/IMG]
[/IMG]
very nice Jeff :thumbsup:
 

·
Premium Member
Joined
·
4,597 Posts
Hey Craig,theres an email for you floatin around cyberspace somewhere.
it hasn't made it to " outer efin' space "yet
theres alot of junk in the atmosphere , hopefully it gets through :rolleyes:
schwabie
 

·
Premium Member
Joined
·
481 Posts
Discussion Starter #9
I have the Percys tool. It is plastic but it works well. It is a small box so if you would like to use it let me know. :yes:
 

·
Registered
Joined
·
2 Posts

·
Premium Member
Joined
·
472 Posts
Sorry to ask off topic question. I got the Percy tool to measer my 63 8 seater with 4 link. According to the tool. I'm able to put a 18x9 in the rear. Not tubed. I have about 1/4 of space between the inner and outer fender wells. Is that enough space. Or should I give it a little more?
 

·
Premium Member
Joined
·
472 Posts
Sorry to ask off topic question. I got the Percy tool to measer my 63 8 seater with 4 link. According to the tool. I'm able to put a 18x9 in the rear. Not tubed. I have about 1/4 of space between the inner and outer fender wells. Is that enough space. Or should I give it a little more?
Is 1/4 inch good enough. Or should it be more?
 
1 - 12 of 12 Posts
Top