Chevy Nova Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hello, I have a question on an oil pan issue. I'm building a 496 ci engine out of my 4 bolt 454 block with 2 piece rear main seal.This has a 1/4" stroked crank. I want to put a larger capacity oil pan with baffles,windage tray,etc. It is going in my 1969 Nova. Does anyone know of an oil pan that will fit, & still let me get to oil filter & starter?
Thanks
 

·
Premium Member
Joined
·
2,115 Posts
I'm using this pan and pumphttp://store.summitracing.com/partdetail.asp?autofilter=1&part=SES%2D3%2D90%2D08%2D910&N=700+4294908216+4294840120+400304+115&autoview=sku kit:
And this windage tray:
http://store.summitracing.com/partdetail.asp?part=MIL-32260&autoview=sku
And studs:
http://store.summitracing.com/partdetail.asp?part=MIL-81151&autoview=sku
With a crank scraper:
http://store.summitracing.com/partdetail.asp?part=MIL-32645&autoview=sku
You'll need this dipstick:
http://store.summitracing.com/partd...&part=MOR-25970&N=700+400105+115&autoview=sku
It's all supposed to fit a stock chassis with a 4.25" stroke crank.No problems with starter or oil filter.
 

·
Premium Member
Joined
·
16,345 Posts

·
Premium Member
Joined
·
16,345 Posts
I took the quote from the link YOU sent, that's why I asked. Your link says:
"Designed to fit tube chassis race cars and marine applications only"
yea, someone did the wrong ID, and everyone else followed.:rolleyes:
Crazy!:eek:

Al

NOTE: if you put in 1970 Nova "454" No application
If you put "396" it gives correct application.

http://store.summitracing.com/partd...4294840121+4294907681&appfilter=1#Application

I have to say, it's pretty bad when you have to sell a part for a company because they don't know how to list it correctly!
 

·
Registered
Joined
·
476 Posts
yea, someone did the wrong ID, and everyone else followed.:rolleyes:
Crazy!:eek:

Al

NOTE: if you put in 1970 Nova "454" No application
If you put "396" it gives correct application.

http://store.summitracing.com/partd...4294840121+4294907681&appfilter=1#Application

I have to say, it's pretty bad when you have to sell a part for a company because they don't know how to list it correctly!
been searching n searching. did u have to notch the crossmember on the 69 u installed it on? i have this pan for my 69 nova, and I'm not sure if I should or shouldn't cut up my crossmember.

any help would b great.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top