[tonygreen2]

rear bumper to body seal how does it go on pics if you have them would be nice thanks in advance.

 

[tonygreen2]

need help i no someone on here has done this help !!!!!!!!!!!!!!!!!

 

[the FLYER]

that piece is held on with staples. best bet is to use a real small diameter drill bit and after removing factory staples, open the holes with the bit. using wire & needle nose pliers, bend and insert wire through seal, through body seam and bend/fold over "staples"

 

[skinnydude]

body and driveline

Ya you have to run a small drill hand push the staples through then bend them over with a pliers,noyhing to it. skinnydude

 

[asteeler4life]

I NEED THIS PIECE TOO! WHERE DID YOU GET IT?

 

[onecarnut]

Here is one source:

http://www.ss396.com/mm5/merchant.m...tegory_Code=SEALSWEATHERSTRIP&Store_Code=Nova

 

[asteeler4life]

Here is one source:

http://www.ss396.com/mm5/merchant.m...tegory_Code=SEALSWEATHERSTRIP&Store_Code=Nova

KOOL, THANKS LO :thumbsup:

 

[the FLYER]

all the restoration suppliers carry it Darnell...

 

[asteeler4life]

all the restoration suppliers carry it Darnell...

I HAVEN'T SEEN IT IN THE BOOKS, I ACTUALLY OVERLOOKED IT, TIL NOW, I KNEW I NEEDED IT, BUT DIDN'T SWEAT IT MUCH! :no:

 

[tonygreen2]

thanks for the help any pics?

 

[Skraps]

I glued mine on with the 3M black weather strip adhesive

 

[batman09]

here ya go

 

[tonygreen2]

you guys are the best thanks so much.