Chevy Nova Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
586 Posts
Discussion Starter #1
I'm installing a Heidts mustang II clip and they provide zero torque specs for the A-arms. Can anyone give me the torque values i should shoot for? Looking in particular the torque values for the upper and lower A-arm nuts. I've had terrible luck witb Heidts customer service and will not be calling them again. Thanks
 

·
Registered
Joined
·
586 Posts
Discussion Starter #3
I sent Tim a pm. Per his instruction the a-arm cross shaft nuts should be torqued to 80-90 ft/lbs. Thanks guys
 
1 - 3 of 3 Posts
Top