Im stumped! Help!

979 Views 5 Replies 4 Participants Last post by Super_Nova, Mar 31, 2009

Super_Nova

Discussion Starter · Mar 31, 2009

Hey,
well I installed the camshaft on my block and then was going to install the timing gears and chain. here is the issue, when installing the gear for the crank It goes all the way in and moves freely the lock thingy(key way?) that should hold it in place is too far in front.... so now what? Please help a brother out!

Save

1 - 1 of 6 Posts

veno

· #4 · Mar 31, 2009

there are two half moon keyways.... remove the first one.. and put it in the slot closest to the #1 main cap.... then.. your cam gear should line up the way you want....

next.. you will need a second half moon keyway for the dampener.

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
Body, Chassis and Mechanical
Drivetrain & Performance
Im stumped! Help!

Top Contributors this Month