Chevy Nova Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter · #1 ·
well to start off this is where i get stuck, i have 4 wires that must be tied into an ignition hot terminal

1) two wires from my aftermarket BECOOL DUAL FANS
2) one wire from my tachometer
3) and one wire from my gauge pod

hope thats enough info, my question is can i tie all four wires into that one ignition terminal on the fuse panel or will i blow the fuses,

and where else can i tie a wire that needs to be hooked to an ignition (key in the on position) source, thanks all info is appreciated i really need some help with this step
 

·
Registered
Joined
·
134 Posts
Discussion Starter · #3 ·
those are going to be all the wires going to my ign source, the two wires from the fans are my fan relays, then just one from my tach, and one from my gauge pod, i have inline fuses on it all just so i dont blow my fuse panel, what do you mean by running the two fan wires to the battery, these wires are for when the key is on, the fans get a signal that it has power, thanks for your help
 

·
Registered
Joined
·
134 Posts
Discussion Starter · #5 ·
it does somewhat, ive realized ive got the ign. terminal and the acc. terminal to work with, im going to put my gauge pod and tach on my ign terminal, and both my fan relays on my acc. terminal, we'll see what happens, i think ill get somewhere from here, thanks you for your help so far
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top