Chevy Nova Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
890 Posts
Discussion Starter #1
Trying to put the little rubber boots on the ball joints of my tci clip.I have to believe the shoulder on the boot should get pushed down between the joint itself and the a-frame for a good seal.Holy crap trying pics and small screwdrivers to no avail.Any tips or words of wisdom please chime in.Correct me if im wrong as well.:D :beer: skull
 

·
Registered
Joined
·
890 Posts
Discussion Starter #3
Custom ifs. They slide over the joint ok but just too much rubber to fit in slot opening.
 

·
Registered
Joined
·
890 Posts
Discussion Starter #4
Talked to tci.they say the boot just rests there it does not go into the open area you would think it does.Seems kinda sloppy that way .Oh well live n learn. thanks for your time.skull:beer:
 
1 - 4 of 4 Posts
Top