You say you want a right side hinge pillar but you circled the left?? Try Tony Record of Chevy II Ranch in Oklahoma. 918-510-2849 He can probably help you.
I've replaced both a-pillar (hinge pillars) in my 67 nova. It has been a job but looking good. They are both in place. What I failed to do was take any good close up photos where they connect to the roof and and underneath in door channel with or without windowshield and trim. I have some photos...
I am attempting to adjust the drivers door on my 65 wagon and am hoping someone could point me in the right direction. I have the door aligned front to rear correctly. The in & out adjustment is also correct currently. I now need to move the door straight down approximately 1/8”. It that...
both my vent windows had no handle on them, the am handles came with a spring washer and rubber o ring, which goes on first? Also does the pin go through the slot?
Do I buy a 5/16" or a 3/8" spot weld cutter to drill out the 5/16" spot welds on my 63 cowl? Objective is to reduce the damage while drilling them out and making weld holes smaller.....but would a 5/16" cut it out?
Thank you!
A forum community dedicated to all Chevy Nova, Chevy II, Acadian owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
