[Jr's70]

It seems that I'm not really sure if I'm in my tolerance of 0.005. And would like someone to point me in the right direction
So at
12 I'm zeroed out
6 I'm -0.008
9 I'm 0
3 I'm -0.006
I think I need to move the bell towards 10:30
If anyone could helps that would be awesome

 

[the tree man]

If those values are not halved yet,looks good to me.The numbers you get are across the whole diameter so cut them in half to get your reading on the radius,from the input shaft to the outside.Puts you at .003 and .004.Should be fine with a pilot bushing.

 

[Jr's70]

Awesome!
I will go ahead and start getting this car back together
Thanks