Joined
·
1 Posts
My husband putting a drive shaft in his 98 S10 and want to know how far the drive shaft hang from the transmission
98 S10 4x4
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Stroker oil pressure issue
Drivetrain & Performance388 stroker running 5w-30, Typically at first start up it is 60psi at idle (in park). Once warmed up it will generally sit around 20-15psi at idle (in drive, TH350). Recently, it has been around 15psi lower at cold start and remains low throughout driving and the gauge drops off completely at...- 2
- 60
-
swagger · updated
-
Rear anti-sway bar help needed.
Drivetrain & PerformanceAnyone have helpful experience with rear anti-sway bars on their 3rd gen? I have built one, 1” cromo, but have a nagging feeling it may be too much for a pro-tour, 4-link set-up. Thanks. Sent from my iPhone using Tapatalk- 2
- 73
-
kimmer71 · updated
-
Serpentine conversion
Drivetrain & PerformanceI'm considering converting to a serpentine belt system. My car is a '69, SBC with factory A/C and power steering. I also want to keep the costs low. One big change that I would like is to move the A/C compressor from the stock driver-side mount to the passenger side, just to help clean up the...- 30
- 711
-
xten57 · updated
-
Headers for a 194
Drivetrain & PerformanceHey guys So I’m thinking about hopping up my 1962 194 and I found a dual carb intake but I’m looking hot some headers but I can only find ones that say they will fit 216/235/261 I read a post on here that said they should still work so I just want to make sure that that is true here is a link to...- 8
- 124
-
ShaneT · updated
-
Pontiac OHC in a '63
Drivetrain & PerformanceSo the journey begins... I am in the beginning stages of installing a '67 Pontiac OHC 230 in my '63 Chevy II. For everyone that says "they'll bolt right in", here is what I have run into so far... Engine length: The engine in the car right now (a '72 250 out of a pickup) is pretty tight. In OE...- 114
- 8K
-
63 bomb · updated
Join now to ask and comment!