Chevy Nova Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
i just purchased a 1971 nova and from how it looks so far someone has already replaced the drivers full quarter but i have noticed that the drivers frame rail has a few dents in it and what not and the back is crumpled up a little from being hit on the bumper , i was wondering if i can replace the frame rail and part of the trunk at the same time or how i should go about it ,i believe they did the wheel houses too, u can feel at the roof line how it meets and its not smooth u feel the seam where they did it and one side is cracking how hard would it be to redo the frame rail and the quarter panel on that side since its already been messed with, the trunk is solid except in the center but underneath next to the frame rail the floor pan has been hit by somthin and a 5 inch long peace has like dented away from the framerail so it isnt connected to it on the one side can i just hammer this back down and re weld a new frame rail?
 
1 - 1 of 1 Posts
Top