[67LOU]

I just realized that it would be a good idea to drill the holes for the quarter panel emblems before we panit the car, does anyone have the correct location for where the holes should be drilled for a 67 super sport. Any help would be great, thanks. Louie

 

[undercvrSS]

If nobody else replies with the info, I'll take some measurements when I get home.

 

[Rookie]

If nobody else replies with the info, I'll take some measurements when I get home.

LUCKY!!!!

 

[67LOU]

Thanks Alot Guys , Any Info Would Be Great.

 

[undercvrSS]

Ok, the emblems have 5 studs on them. I measured from the top (inside) of the quarter panel to the middle of the top stud, and it's 5 1/4". then I measured from the rear of the panel, also inside, and it measured 5 1/2" to the center of the top stud. That will get you the center line for the one stud, after that just make the emblem level, mark the other holes, and you're good to go. Hope this helps.