[Catch22]

Hi guy's, just wanted to say hi, this is my first post and it's a question for my dad's 67 Nova that he will be putting a 327 engine with a turbo 400 transmission. He has a couple of spare crossmembers and we want to modify one for the turbo 400.
Does anyone know the original dimensions from the face of the bell housing to the bolt holes on the original crossmember. Then I can take the dimensions off of the turbo 400 and make the modifications.
Thanks Mike

 

[Mike Goble]

Here are the dimensions of GM transmissions:

http://non-stoptransmission.com/en/info-chevrolet.php

 

[Catch22]

Thanks Mike

 

[Pragmatist]

I didn't think a TH400 would fit stock floor.

 

[Repointer1]

I didn't think a TH400 would fit stock floor.

I went to put a Turbo 400 in my 67 years ago. All bolted up and when I went to raise the rear of the tranny to install the cross member no such luck. The tail shaft housing was too big. It was 20 plus years ago so my memory is a bit foggy but it was more work than I wanted to do at the time so went with a Turbo 350.