Chevy Nova Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,474 Posts
Discussion Starter #1
Replaced my deck lid with one from a different year/model; actually I think it's off an Acadian.
Want to confirm how may clips hold the reveal moulding on; I know about the outside clips which attach with screws but I'm not sure how many stud type clips are used as I only have 3 right now. Also are the holes basically centered on that mounting surface.
Now for the diecast; currently I have 4 holes which are of no use for my 6 stud piece but they maybe useful for reference. They are just slightly below the body line; is this the correct location as far as vertical positioning?
Any tips for marking the holes; I was kinda shocked when i measured the ctc of the studs and the center pair aren't symetrical with the other studs.
 
1 - 1 of 1 Posts
Top