63 console measuerments

1 - 1 of 1 Posts

nightstaker2400

Registered

Joined 2 mo ago

10 Posts

Discussion Starter • #1 • 14 d ago

Does any on happen the have the measurements for the bracket locations for a 63 center console?.
Also looking for a stock steering column for a 63 with automatic on the floor.
Thanks

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

Need photos of 66-67 Nova a-pillar area

Body and Interior

I've replaced both a-pillar (hinge pillars) in my 67 nova. It has been a job but looking good. They are both in place. What I failed to do was take any good close up photos where they connect to the roof and and underneath in door channel with or without windowshield and trim. I have some photos...
- 1
- 82
- M
  mike-g · updated 15 h ago
65 Wagon Drivers Door Adjustment

Body and Interior

I am attempting to adjust the drivers door on my 65 wagon and am hoping someone could point me in the right direction. I have the door aligned front to rear correctly. The in & out adjustment is also correct currently. I now need to move the door straight down approximately 1/8”. It that...
- 4
- 78
- L
  ldamm · updated 17 h ago
67 vent window handle

Body and Interior

both my vent windows had no handle on them, the am handles came with a spring washer and rubber o ring, which goes on first? Also does the pin go through the slot?
- 2
- 71
- Zonie · updated 1 d ago
66 Nova Repop Grille

Body and Interior

66 Nova SS REPOP grille, how is the quality and do they fit well? I searched the forum and did not find anything on this.
- 6
- 169
- menova · updated 2 d ago
5/16 Spot welds...what size cutter to buy?

Body and Interior

Do I buy a 5/16" or a 3/8" spot weld cutter to drill out the 5/16" spot welds on my 63 cowl? Objective is to reduce the damage while drilling them out and making weld holes smaller.....but would a 5/16" cut it out? Thank you!
- 4
- 149
- Shoebox · updated 2 d ago