Chevy Nova Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Steering, Suspension, and Chassis
    In the process of rebuilding my front suspension and noticed my passenger spindle has a shallow groove around the shaft where the outer bearing rode. What is the best way to polish the groove out?
  2. Wheels and Tires
    Does anyone have a definitive answer as what the exact wheel specs are for the original steel wheel on a 66-67 Nova SS? I do know they were 14 x 5.5 with a 5 x 4.75 bolt pattern. I would like to know the back spacing and if in fact they had the 4 dimples around the edge of the rim like the...
  3. 1st & 2nd Generation Chevy II/Nova's
    So, I have a 66 2dr sedan with a small block 355, th350, and CBR rack and pinion steering kit (lower control arms,swaybar, tilt column,ect.). The rest of the car is stock. I do have a ford 9" that i got from a junk yard the i would like to put in as well. So here is my goal for the car. I want...
  4. Wheels and Tires
    I have a 62 Sedan and am wondering where I can find some 4 lug wheels. I have looked many places but can't locate any... Thanks, Jason
  5. Wheels and Tires
    Most all wheel/tire combo threads I have read said that you could run a 255/60/15 rear tire with 4.5" backspacing. I was wondering if you could fit that tire size on a 15x7 wheel with only 4", 4.125" or 4.25" of backspacing?:confused:
  6. Steering, Suspension, and Chassis
    Whats up fellas? Question for ya. I'm needing to make my 70 Nova easier to get in and out of due to my roll bar front strut. I've been looking at quick release steering wheel hubs from summit, jegs, wilwood, speedway etc. They all say that they are weld on only and are for 3/4 or 5/8 shafts. Has...
  7. Show and Shine
    My secret - revealed! Simple, simple products that you probably already have in your garage! Process for tires -Armor all. Normally used for interior vehicle surfaces. Many may already know of this. Cleans up the tires very well and leaves a not-too-shiny but clean, new look. I normally go over...
  8. Steering, Suspension, and Chassis
    I noticed a clacking noise in the front drivers side wheel while driving home the other day. I took the drum off and notice the brakes needed to be replaced so I did that and the oise is still there. The strange part is that I cannot hear the noise at any speed lower than 20 or any speed higher...
1-8 of 8 Results