Chevy Nova Forum banner
floor pan
1-8 of 8 Results
  1. Body and Interior
    So I'm trying to replace my driver side floor pan on my 1970 Nova with a full size patch panel, I've gone and carefully trimmed away the rotted floor to the point where I can drop the new panel in and line it up. I have noticed that, along the rocker panel, the front lip and rear lip, where the...
  2. Steering, Suspension, and Chassis
    Hey everyone So I am in the process of replacing the floor pans in the passenger side of my first gen and I have run into a bit of a problem. When trying to fit the pan I noticed the it would not sit flush because it was hitting (not sure what the correct term for it but the support in the...
  3. Body and Interior
    Hey Ya'll, Replacing the floor pans on my 70 Nova. Question on how to address the new floor pan flange where it meets the frame support and rocker. The original floor pan is spot welded between the rocker and frame support. Is it best to 1) bust loose the frame support, tuck in new floor...
  4. Body and Interior
    Greetings all. I've finally got the new floor pan installed in my 70 Nova but I need some help and or direction as to where to cut the whole for the shifter for the center console. At this point, I'm not too thrilled about guessing so I wanted to see if there are some members that may have...
  5. Body and Interior
    I'm having to replace the firewall and part of the front floor pan where the firewall to floor brace extensions are due to the previous owner warping and burning holes in the metal when welding on new braces. I will have to remove the front clip then cut out the firewall and floor around the...
  6. Body and Interior
    Shes getting put back together:bounce:
  7. 1st & 2nd Generation Chevy II/Nova's
    I'm looking to hopefully start on my 67 sedan in the next six months or so, and I'm trying to get some ideas on how to plan my project. The information I need to know is how much time I need to plan for each of the following components/stages? 1. Competition Engineering weld in sub-frame...
  8. Body and Interior
    Hey i got this ugly hole in my front floor pan but not all but just the rectangular parts. I got pictures with little description also website for whole part below pictures and my guess an 18 gage sheet of metal. http://www.rockauto.com/catalog/moreinfo.php?pk=2469758 Thanks for all the help.
1-8 of 8 Results
Top