Chevy Nova Forum banner
control arms
1-8 of 8 Results
  1. Originality
    Hi Everyone: I am trying to retain and refurbish my original 69 Heater Control box. I bought the car with two of the control knob arms broken off, so I bought replacement slides/arms. I checked the forum and no previous posts of how to disassemble the who control box/module or replace...
  2. Steering, Suspension, and Chassis
    Picked up a 76 Nova SS and finding that obtaining aftermarket parts is becoming a challenge. 74 Nova SS and 74 Nova aftermarket parts seem to be plentiful. Are the front upper and lower control arms the same the years 1974 and 1976?
  3. 1st & 2nd Generation Chevy II/Nova's
    I am a newbie and hope this is the correct place to post this thread. I just wanted to share my experience improving my ride with a new CPP mini K-member front suspension upgrade that includes upper and lower tubular control arms. I also added a anti-sway bar to improve the cornering handling...
  4. Drivetrain & Performance
    Does anyone know where I can find stock replacement control arms (upper and lower) for a 73 Nova? Everywhere I look I see the tubular ones which are way too much and they lower the car to a a point that it scrapes. Any help would be greatly appreciated.
  5. Steering, Suspension, and Chassis
    just put new control arm bushings , ball joints, HD 350 coil springs and new shocks in my 68. and the front of the car is still not level ? and ideas. Thanks Rusty
  6. Steering, Suspension, and Chassis
    I need some help! :( I recently bought a set of CBR upper control arms and already have a QA1 coilover setup from The autofab coilovers comes with a lower mount that works with the stock control arms and a 3inch tbar, but won't work with the cbr setup, so since the bolt...
  7. 3rd Generation Chevy II/Nova's
    I am trying to find online junk yard search or any site that has used parts. I'm about to replace my control arms, first time doing this. And I dont know how to use a coil spring compressor. I have heard they can jump out on ya, im kinda worried hope i dont put an eye out!
  8. Steering, Suspension, and Chassis
    I was one of the early buyers of the CPP mini subframe kit, which then sat in my basement for two years. Again I will refer you to Patman's article, and NOGO's original thread for install details. It went pretty easily, since the rivets on my front strut braces were already replaced by...
1-8 of 8 Results