Billet rad.cap cover

[theracer]

My custom billet rad cap cover come off the rad, cap.
It looks like it was stuck on with bondo.
What is usually used to glue them back on ?

Thanks

[chriss68]

Glue.:yes:

[klean63]

Glue.:yes:

Are you sure it's just glue and not "super billet radiator cap cover glue"?:eek::D:D

Try this http://jbweld.net/products/industro.php

[Shane65]

Make sure the glue can take the heat. Likely an epoxy type would work well.

[veno]

"OL" Yeller aught to do it

[NovatoriusRex]

Not to be a wet blanket on this question/answer fest, but wouldn't it be expensive to have to have to buy a new billet cover every time you need to replace the radiator cap if you epoxy it in place? :confused:

Rad caps don't live forever. :no:

[theracer]

I think JB Weld or Liquid Nails ,which was suggested from another source was the most reasonable suggestion.

[veno]

liquid nails will not last... an putty epoxy should be your solution.... any Plumbers epoxy, PC7, JB, Devcon all will suit this application.. just make sure to use a putty form epoxy and that the surfaces are residue free.

[Dnova]

I used side molding tape...