Need help pulling a steering wheel

This is in my 63 hardtop. Should be a pretty straightforward deal except for this, what kind of screws are these?
http://www.nocturnaloner.net/Nova/steeringscrews.jpg
They are the three screws that hold in the plastic spacer. The 62 shop manual shows flat head screws here, but no such luck. I need to know what they're called, and where I can find a tool to fit them.

I've seen them before but dont know what they are called. you can get a bit in a set from sears I would think

Ok, I found out on another forum that I will need a clutch driver to remove them.

I was able to get a small screwdriver in diagonally, and turn them. Now to figure out the puller.

Greg, ya havin' probs ??? the wheel should have two 5/16-18 threaded holes... that's where ya screw in the bolts fer the puller.

i have a puller and my old 64 wheel in my shop. i can grab a quick shot for ya if it'll help ya out Bud... lemme know if i can help ya.


AAAAAARGH !!! :D

Thanks for the bolt size info, Johnny. I mighta said 1/4" if I was just eyeballin' it. No, the wheel came off easy. Of course I did have to get the 5/8 bolts from the hardware store, the ones that the Autozone puller comes with are too big.