chassisworks 4 link setup

im just bout ready to getter on the street, 64 ht pro street. i have a chris alstons rear 4 link clip.
my front 4 link mount is 4" off the ground.
what holes should i use for the mounting of the top and bottom links to get the best street ride and a fairly good launch. i have the maping sheets for the different set-ups , just need a good place to start.

thanks

Why not give Chassisworks a call and get their recommendation? Mike from there is on this forum from time to time also.

What is your est. HP, engine size, trans type, & gear ratio

techguy
420 hp 383 with a 700r / 3:89 9" fd.
and 31" x 18.5 hoosier pr street radials

thanks

If using a trans brake, i would start with an intersect point of about 43-45"
& about 7-8" off the gound.

if going foot brake, i would try 33-35", about 8"-9" off ground


do you have adjustable shock in the rear ?

techguy
no adj shocks, just the ones that came with the kit.
that 8-9" off the ground ,are you talking about the intersection point.
right now im at A3 and E7 which gives me 37.75 and 6.25 intersection point.
see my first post , the front mount is 4" off the ground , it sits looooow .

techguy
that 8-9" off the ground ,are you talking about the intersection point.
right now im at A3 and E7 which gives me 37.75 and 6.25 intersection point.
.

I see, we can't raise it anymore, so if you lower the upper front down to E6
that is 30 5/8 & 6 5/8" .
Once you try one setting, you should "move" in one direction to see how the car responds. if the change improves 60 ft times, continue in that direction.

techguy ,

think i'll leave it at A3 , E7 to start.
will this be ok for the street ?
WHATS YA THINK !!
thanks for the help !

it will be fine....try it , change at the track, see if it helps.

rinse, lather , repeat