TCI clip with power steering

I just got my TCI front clip and I got the power rack with it. I am going to be running a ididit column and a Big block. How did some of you guys run your steering shafts down to the power rack. Did you wait until the motor was in with headers. Also what are all the parts I will need to hook up the column to the rack any help would be great. Its on a 66 sedan.

You need to have everything in place before you set up the steering.

As far as what you need to do it, you'll need either some splined or DD shaft, and the correct u-joints. Borgeson has all the parts, or you can go through CPP or similar.

Again, you'll need to have the engine in with the headers to know how many u-joints, or how its gonna run.

I will try to send some picture tonight ....i have your exact setup but a LS you may want to go thru my pictures i may have one of the colum in their.


PM me your mail and i will send the pictures..


Steve

i have a tci clip with a big block , manual rack and new aftermarket column
i have pics of my shaft i made , i am using the tci s&s headers

ck my photobucket link for pics

Also if you guys are running a big block what are the best fitting headers that fit a 66 nova with a tci clip. can you run the tci headers for a small black. Thanks

Here's a couple picts

http://i252.photobucket.com/albums/hh17/snolan1/Picture180.jpg

http://i252.photobucket.com/albums/hh17/snolan1/Picture178.jpg

http://i252.photobucket.com/albums/hh17/snolan1/Picture183.jpg



Thanks
Steve

SNOLAN, who's headers you using. They look like they fit real nice.

They are sold by TCI, made by S&S in AZ ....fit nice but they do HANG LOW..

Very fairly priced.

Steve