I bought the CCP 6467WBKS kit months ago and I finally got around to installing on my 64 tonight. Unfortunately, the kit was missing the grease seals, would anyone know what grease seals fit the CPP rotor? I was hoping to have the install done tomorrow. I compared the rotor to a 3rd generation rotor, the seal hub may be the same (the rotor itself is not located on the same place on the hub). The kit was also missing the washers that Pat Manusco shows in his write-up. I used some I had, hopefully they are not too thick to cause interference. Thanks.
TomM
19th-January-2009, 07:50 AM
Call CPP and ask them, at best they owe you the seals and washers. I had them email me what parts they used for the various upgrades I did, so I could develop a parts list for future repairs....
Good luck....
T,
nova_rookie
19th-January-2009, 09:02 AM
I was hoping I could start on this morning (Eastern time). I'll call them when they open up.
Thanks,
Mike
Call CPP and ask them, at best they owe you the seals and washers. I had them email me what parts they used for the various upgrades I did, so I could develop a parts list for future repairs....
Good luck....
T,
fanbelt
19th-January-2009, 12:56 PM
Hey Mike, I'll be over there later this week if you need help. I've never done this upgrade before but I'm pretty handy w/ wrenches. PM or call me, you have my number. Be glad to help. Mike
TooManyReels
19th-January-2009, 09:03 PM
Is this the new zero offset front brake kit, if so, what is the drop spindle height..
Eddie
nova_rookie
20th-January-2009, 01:43 PM
This is the stock spindle kit. I got it all put together on Monday, the grease seals are the 3rd generation seals. Including the seals, I had a few other minor issues but it turned out pretty well. I also got the booster and MC in. Just need to run the rear brake line.
Mike
Is this the new zero offset front brake kit, if so, what is the drop spindle height..
Eddie
TomM
20th-January-2009, 01:56 PM
Good deal, glad you "got er done".......
T,
nova_rookie
20th-January-2009, 03:36 PM
Hey Mike, I'll be over there later this week if you need help. I've never done this upgrade before but I'm pretty handy w/ wrenches. PM or call me, you have my number. Be glad to help. Mike
Mike,
Thanks for the offer but I got it together on Monday. When I got all the parts I needed, the CPP stuff went in pretty easy with a few minor issues. I need to run one more brake line and I hope to get that done tonight. I'll let you know if I see a 5 lug rear-end around.
Mike
fanbelt
20th-January-2009, 05:17 PM
You're welcome, Mike. Just so you know, I'm leaving tomorrow headed that way. Close friend passed away in W-S. Be there a few days. I'll have a little time if you need me. I want to talk to you about that body section we discussed. If you still have my cell #, call me. If not, post and I'll call you, on your schedule. Mike