- Instructions -new CPP suspension kit
- 4-door question
- changing shocks on a 66 nova
- brake caliper question
- mustang II sub frames
- energy suspension control arm kit???
- Transmission Not Centering
- Best Traction Bar?
- replacing front coil springs
- Shopping for a new brake distribution block
- chasis works front clip
- Leaf Spring Axle Brackets
- Power steering hose help
- lowering / raising heidts front suspensions
- best power booster swap and why
- best power booster swap and why
- Subframe connector help
- rancho 9000
- Disc Brake/Lowering/Tires Rubbing???????
- fuel canister
- drive shaft??
- Are disc brakes really that much heavier than drums?
- mono leaf or multi leaf
- Moroso Trick Springs
- My brake dreams have been shattered
- Master cylinders...
- classic performance products disk brake kit
- I need 17" wheels
- Will gold colored grade 8 and other hardware RUST?
- Front sway bar
- air ride tech./ heidts
- cpp tubular control arms
- Help with Mustang clip springs
- American Racing center caps
- What steering gearbox fits a 70 Nova
- So I just installed some Hotchkis springs...and what the @#*$
- front suspension and mini tubbing
- standand to power brakes 69
- Header Help
- Just got off the phone with CPP
- got alot done
- Flaming River Rack and Pinon and Z bar for clutch?
- narrow stock gas tank
- 67 Rear Shock Install
- Mr Acadian aka Scott from Hitman Hotrods
- New idler bearing conversion wont fit.
- upper and lower control arms
- pitman puller?
- CPP tubular A arm/K member from summit
- Chevelle rear in my Nova
- 3.5" rims on the street?
- Brake Line OEM or Stainless question
- Part number?
- '62 Steering
- '66 Chevy II Brakes (Drum):
- dropped spindles for drum brake
- leaf springs
- Power steering box question
- CPP with coilovers???
- Will these fit?
- dog dish rally
- 66 stock steering wheel install ????
- Manual steering lube ?
- Tires rubbing - mill wheels?
- rear diff
- Changing Steering column, 65'
- got a problem
- Need help with these stupid subframe connectors
- Steering Box
- lowering the rear?
- freekin sway bar
- heidt's headers and a 4 speed
- I broke down
- 67 Nova Front
- caltrack traction bars?
- Recomended tire size
- Lesson learned!
- Chassisworks steering
- Steering column Question
- Lowered her 4" today!
- Front brake question on 3rd. gen...disk brakes
- Options to change steering box on 67
- Home made traction bars
- Front drum brake upsize
- Master cyl problems
- Rear Tire Fitment
- Finally!! I'm off of my *****!!!
- Front Tires Rubbing
- Upper Shock Mount
- 67 Steering Column Problem
- wheel backspacing and wider rear tires
- cpp parts..coming?
- centering the steering box
- Traction Bar Questions
- 70 Nova Rear Axle Shifting...Any ideas?
- Need help deciding what suspension set up to use
- traction
- Bills II conversion update
- Master cylinder
- RE: Headers
- TCI 4 Link
- What Happened to the Thread?
- cpp mini sub frame ?
- Chassisworks Subframe Connectors
- Subframe Connector Install and Roll Cage Install Updates
- nice master cylinder?
- Irs Conversion
- Do I really want Droppped Spindles?
- Cpp Sub Frame Problem
- backset on wheels
- shackles
- Brake Tech Bulletin & Troubleshooting Giude
- cpp update
- cal trac slid-a-link ?
- Mustang II front end
- Hubcaps over aluminum wheels......
- TCI springs
- Ladder bars photos
- S&w Vs Ce
- chasis works front clip and rear 4 link
- can I fit these slicks?
- K-1-9/K-19 Chevy Rally Rims
- CPP master cylinder installed w/pics
- Flaming river bolt in rack 1st gen
- Manual brakes and bore
- Power Steering or Manual...
- pro street parking brake Q?
- '66 Chevy II Power Steering:
- Mustang II
- Taking bushing out of CPP control arms
- Weights on mono leafs?
- Early Stove Pot Master Brake Cylinder
- Where are the 4.5" B/S wheels in stock?
- Steering linkage interchange?
- Can good leaf springs really eliminate wheel hop?
- How do I remove rear end axle seal from a 10 bolt?
- Upper A-arm bushing removal tool
- removing power steering
- Rear suspension & springs
- CPP Subframe squeaks
- Torque specs on upper control arms
- Measurement needed 63-67?
- Tubbing a 67
- 1st gen wheels
- A couple of power steering questions
- CPP front disc upgrade: manual or power?
- Rack in 68/72
- big block with tci front clip
- 67 steering box
- still nothin!
- Lowering leaf springs to normal height???????
- CPP arms and brakes installed, a few questions...
- Non-Nova, Grand Prix rear brakes?
- 64 with a straight axle--any help or ideas?
- Brand of Sway Bar?
- Multi-leafsprings
- brakes again
- 1st gen keeps going toe in
- brake indicator light
- 64 Nova Tie rod adjustment
- Front end suspension parts/bushings?
- Why
- C5 corvette brake conversion
- Rear end not center in my 3rd Gen??
- dot 5 brake fluid
- Brake Problem!!
- Removing the clips
- What wheels came stock on 66 SS
- Nova power brake problem
- QA1 suspension
- 1963 Power Steering
- Wheelbase
- 250-6 Power Steering
- What make it Quick ratio steering?
- Nova Centerdrive Truckarm Kit
- cpp update
- cpp A arm kit ..measuring
- ball joint torque spec's
- CPP lower control arm does not line up
- just got new 17" wheels, now what size tires to order?
- How to assemble summit's wheel tubs?????
- Drag car suspension
- Today's mini-project
- Got my CPP Lower A arm / K Member kit!
- Classic Industries Disk brake kit
- What front shocks are you running?
- disc brakes/power booster kits
- ready to put in a front clip.... help please..
- The cpp parts arrived!
- KYB or other shocks?
- cpp mini subframe
- Steering wheel for my 71
- A REAR END DEBATE: floating (pinless) springs and the dangers of the rear moving
- Core support 1st gen
- t.c.i. front clips
- The unofficial CPP stock spindle front disc brake writeup (64-67)
- 66 & 67 Front to Rear Brake Line Question
- Drop spindle vs. stock disc brakes?
- Moving Rearend?
- I got some chro-moly goodies yesterday
- Dropped spindles and exhaust are on.
- brake drums wont fit over shoes!!
- 4-Link Setup Questions
- power steering pump squeal
- power brake rod
- Replacing mono-leaf with multi-leaf
- sway bars
- 9" axle removal
- 72 Nova Maximum Rear Tire Size
- IFS for 66 Nova
- IFS for 66 Nova
- Header / Steering box clearance issues (with pics)
- Powder Coating
- Newbies body mount question
- Rear Sway Bar ???????
- 1st gen front hub swap
- it won't work..without modification!!!!
- The steering shaft for "Bills II" R&P
- Man am I impressed!!!
- CPP A-Arm kit vs. Global West Upgrade + Adj. strut rod
- Global west lock out
- 4-wheel manual drum brakes
- Big Block Install
- Brake upgrade question-what can be used?
- global west & cal tracs
- help with rearend overhaul
- Anyone running the QA1 coil over front shocks/springs set up?
- air ride???
- WTB or info needed on 64 front wheel cylinders
- WTB or info needed on 64 front wheel cylinders
- Master cylinder rebuild
- front clip
- brake bleeding for dummies (me)
- Which clip?
- shims
- Tips for CPP kit install
- Dif. between 3rd & 4th gen body bushings?
- If I had to do it again
- CPP Lower kit
- 2 motor mount styles..
- Progress Pics...Roll cage and fuel cell...Take 1
- front spring
- Fenderwell headers with aftermarket clip
- Noisy brakes or ?? - any ideas?
- Mustang II brakes
- brake shoes
- Update on front end!!!!!!!!!!!
- Anyone move rear shocks to the inside??
- Steering Column Question
- Front suspension/brake upgrade